Thursday, May 15, 2014

Speed Vise

gdavis2265 posted to the HSM forum about his speed vise for the drill press. It looks like a very nice design:
"Here is a speed vise that I made - it can be used vertical / horizontal or flipped to the opposite side - it works really well, and was cheap to make. It pivots at the end and slides fast to locate the part under the drill - the all-thread clamps tightly locking the part in place, and you only need to hold the handle with the left hand while drilling to keep it in place. I milled some steps in the jaws to act as quick parallels. I used it on the DP for a while until I bought a 8" Heinrich vise (love that thing) and now this has been re-pourpused to bandsaw duty, as it works really well for holding / pushing / and guiding parts on the vertical bandsaw.




Speed vise being used with circle cutting jig on vertical bandsaw.


Just some layout I did to show the capacity of the vise."



Something he didn't specifically point out were the notches milled into the edges of the jaws, great for holding thin plates. And the drilled and tapped holes are another thoughtful addition. Great work!